The LUMETRON HF-2 Spark Generator, from LUMETRONICS is designed and manufactured to provide a compact source of high voltage, high frequency output to check and detect the presence or lack of vacuum in evacuated shells such as GLS and Fluorescent Lamps, bimetallic Fluorescent Starters, Discharge Lamps etc. It can also be used to detect leakages in such products.
Test plug for co-axial socket as per IEC 60065 and IEC 62368-1:2023
The LUMETRON RP-20x34 Hand Held Spray Nozzle from LUMETRONICS is designed and manufactured to determine the extent of protection provided by an enclosure against ingress of water and verified by a standardized test method as described in IEC 60529 “Degrees of protection provided by enclosures (IP Codes)”.
The Lumetron MCT 5 circular blade cross cut tester is designed to test the adhesion and brittleness of dry coats of paint on their substrate by means of a set of six circular blades and two guide blades. Testing is as per Test Method ASTM D3359
Taper test pin as per IEC 61032
The Lumetron CT 20 Compression Test Apparatus is designed to perform tests specified in many standards where resistance of insulating materials to elevated operating temperatures is to be determined. It confirms to the requirements of IEC 60320-1:2021
The LUMETRON SIT-50 Series Spring Operated Impact Hammers, from LUMETRONICS, are designed and manufactured to perform the test specified in many standards, specifically IEC 60068-2-75, to determine compliance with requirements concerning Mechanical Strength. Mechanical strength test to verify the quality & safety characteristics of products, as required by national & international safety regulatory agencies such as BIS, UL, CSA, VDE, BSI, DIN, IEC, etc can be conducted with this equipment.
The LUMETRON HD-07 Hot Deformation Test Set, from LUMETRONICS, is designed and manufactured to carry out safety tests specified in many IEC, like IEC 60811-508:2012/AMD 2:2023, and other standards for verifying compliance to pressure applied on insulating materials at high temperature.
This is used to perform the test specified in many standards to determine compliance with safety requirements, particularly mechanical strength of test samples.
Calibrator for SIT 50 Spring operated impact hammer. Only calibrator of its type in India built as per the IEC standards of IEC 60068-2-75
Copyright - Metrix Instruments | All Rights Reserved
Website by Webmaddy
